SOMFY Sonesse Ultra 50 RTS - Manual (Page 9)

9 Copyright © 2014 Somfy SAS. All rights reserved.
EN
Images not contractually binding
2.4.3. Restoring the original configuration
Only switch off the power to the application to
be reset.
This reset deletes all control points, all the sensors
and all the end limit settings, and resets the motor’s
favourite position (my).
1) Position the motorised product at the mid-height
position.
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15
seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on: the motorised
product moves for a few seconds. (If the application
is at the upper or lower end limit, it will make a brief
up and down movement).
6) Press the PROG button on the Somfy local
control point for ≈ 7 seconds, until the motorised
product moves up and down twice:
→ The motorisation is reset to the original
configuration.
- Repeat the commissioning procedure (see
Commissioning) section.
3. Use and maIntenanCe
This drive is maintenance-free
For the safety of goods and people, Somfy motors are equipped with thermal protection
that will trigger the motor stops in the event of overheating.
Repeated achieving this protection can degrade engine performance.
If the motor goes to thermal protection, please check your installation and check that the
motor is rated for the intended use.
A normal installation is not expected to trig this protection.
To avoid the drift of the end limits, do not cut the power supply more than 1 week.
3.1. UP and doWn bUttons
Pressing the
Λ
or
V
button fully raises or lowers the
motorised product.
3.2. stoP fUnCtIon
The motorised product is moving.
- Briefly press my: the motorised product stops
automatically.
 1) 2)
3) 4)
5)
A
PROG.
B
A
PROG.
B
A
PROG.
B
A
PROG.
B
A
PROG.
B
6)
PROG.
A
A B
MY
X 2
C
1)
2)
