SOMFY Sonesse Ultra 50 RTS - Manual (Page 6)

6 Copyright © 2014 Somfy SAS. All rights reserved.
EN
Images not contractually binding
2.3. CommIssIonIng
2.3.1. Pre-programming the rts control point
1) Switch on the power supply.
2) Press the
Λ
/
V
buttons on the RTS control point at
the same time: The motorised product moves up and
down (fast raising and lowering), and the RTS control
point is pre-programmed in the motor.
The motorisation is in programming mode for ≈ 10 min.
2.3.2. Checking the direction of rotation
1) Press the
Λ
button on the RTS control point:
a) If the motorised product rises (a), the direction
of rotation is correct: Move onto the section
entitled “Setting the end limits”.
b) If the motorised product lowers (b), the direction
of rotation is incorrect: Move onto the next step.
2) Press the my button on the RTS control point
until the motorised product moves up and down: The
direction of rotation has been modified.
3) Press the
Λ
button on the RTS control point to
check the direction of rotation.
2.3.3. setting the end limits
the end limits can be set in any order.
1) Raise the motorised product to the desired position
by pressing the
Λ
button.
2) Press the my and
V
buttons at the same time until
the motorised product moves.
The upper end limit is memorised.
3) Press the
my button when the motorised product
reaches the desired lowered position. If necessary,
adjust the position of the motorised product using the
Λ
and
V
buttons.
4) Press the my and
Λ
buttons at the same time until
the motorised product moves.
The lower end limit is memorised. The motorised product rises and stops in the raised position.
2.3.4. Validation of the setting
To confirm the end limits, press the
my button until
the motorised product moves up and down.
The end limits are programmed.
2 1
a
b
=
=
a
b
=
=
a
b
=
=
1)
2) 3)
1) 2)
3) 4)