Nozzle kit installation, Accessories, Turbo turfjet tips) – Smithco Spray Star 3000 (sn 3500 – Current) Parts & Service Manual User Manual
Page 95
93
Accessories
14-100 PLUMBING & 16-807 NOZZLE KIT PARTS LIST
(TURBO TURFJET TIPS)
REF#
PART#
DESCRIPTION
QUANTITY
1
14-100
Boom
1
2
16-795
Square clamp, 1
12
3
16-796
Diaphragm Check Valve, Single
(complete with 8 & 9)
6
4
16-797
Diaphragm Check Valve, Double
(complete with 8 & 9)
6
5
8888-19
Orange PVC Hose,
1
/
2
"
4
6
18-224
Hose Clamp,
1
/
2
"
28
7
16-137
Fitting,
1
/
2
MPT x
1
/
2
HB
6
8
16-798
End Cap
12
9
16-960-06
Diaphragm
12
10
8888-8
Orange PVC Hose,
1
/
2
"
6
11*
15-588
Turbo TurfJet Tips
12
12*
16-800
Gasket
12
13*
16-921
Quick Teejet Cap
1
/
4
" FPT
12
14*
16-199
45° Street Elbow
1
/
4
" PT
12
15
16-135
Fitting,
1
/
2
MPT x
3
/
4
HB
3
18-077
Hose Clamp
3
16
16-200
Ball Valve,
1
/
4
FPT
2
16-136
Fitting,
1
/
4
MPT x
1
/
2
HB
4
17
8888-9
Orange PVC Hose,
1
/
2
"
4
*
16-807
Nozzle Kit
12 each
NOZZLE KIT INSTALLATION
(TURBO TURFJET TIPS)
All measurements are done from the fitting on center boom with booms in-line. Nozzles are exactly 20" apart.
1. Install check valves (A and B) above the square tubing and pointing to the rear.
A.
Single Ended Check Valve (Ref# 3) and Clamp (Ref# 2), install with fitting toward middle of boom.
B.
Double Ended Check Valve (Ref# 4) and Clamp (Ref# 2).
C.
Fitting (Ref# 17)
D.
Ball Valve and Fitting (Ref# 15)
2. Place ball valve (D) between the outer check
valves on both right and left booms. Connect
the check valves together using the
1
/
2
" hose
and hose clamps.
3. Install Raindrop nozzles into nylon 45° elbow. Install nylon elbow into threaded
quickjet caps. Attach caps and gaskets to the check valve. Position Raindrop
nozzles so they point to the rear, and 45° down from horizontal.
4. Fill the tank
1
/
2
full of water. Place unit on a hard and level surface. Adjust boom
height according to the Nozzle Selection Chart. Turn on spray and observe the
amount of overlapping spray between adjoining nozzles. There should be 100%
overlap. The edge of the spray from one nozzle should reach to the center of the adjoining nozzle. If
required, adjust boom height until the correct overlap is achieved.
Strainers are not supplied with Raindrop nozzles. Use 50 mesh slotted strainers (16-802) on nozzle tips smaller
than standard.