Smithco Spray Star 3000 (sn 3500 – Current) Parts & Service Manual - Manual (Page 85)

83
Accessories
BOOM WIRING DIAGRAM
PART# DESCRIPTION QUANTITY
PART# DESCRIPTION QUANTITY
8853 Female Spade Connectors 2
15-472 Switch Boot 2
11-158 Linear Actuator with 4" stroke 2
16-755 Switch 2
16-810 Wiring Harness (for Spray Star 1600) 1
33-190 Wiring Harness (for Spray Star 3000) 1
22-075 Nylon Tie 10
33-273 Fuse 30 amp 1
Use Dielectric Grease On All Electrical Connections
NOZZLE ASSEMBLY
REF# PART# DESCRIPTION QUANTITY
1* 16-920-03 O-Ring 1
2* 16-920-05 Diaphragm Teflon (Optional) 1
3* 16-920-06 Diaphragm EPDM Rubber (Standard) 1
4* 16-798 Chemsaver End Cap 1
5 16-800 Gasket Viton 1
6 16-921 Cap 1
7 15-588 Turbo Turf Jet Tip #8 1
* 16-996 Body 1
When the 16-920-05 Teflon Diaphragm is used, it is placed in the assembly in front of the 16-
920-06 EPDM Rubber Diaphragm. Nozzles are located 20" (51 cm) apart on the right, left, and
center tubes. There are predrilled holes in all tubes. The Nozzle should be at a 45° angle to
the ground for proper application.
For all 18' Booms: The eleven 16-996 bodies are installed on the boom sections. The
eleven 16-800 viton gasket, 15-588 Turbo Turf Jet Tip #8 and 16-921 cap are in the small parts
bag.
For all 15' Booms: The nine 16-996 bodies are installed on the boom sections. The nine
16-800 viton gasket, 15-588 Turbo Turf Jet Tip #8 and 16-921 cap are in the small parts bag.