Smithco Spray Star 1000 (sn 100489 – 100523) Parts & Service Manual - Manual (Page 99)

97
Accessories
10-378 FOAM MARKER PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 HB-14-20-075 Hex Bolt, 1 /
4
-20 x 3 /
4
4
HNFL-14-20 Flange Lock Nut, 1 /
4
-20 4
2 10-413 Foamer Brace 1
3 HB-12-13-150 Flange Bolt, 1 /
2
-13 x 1 1 /
2
1
4 HBFL-516-18-075 Flange Bolt, 5 /
16
-18 x 3 /
4
2
5 10-409 Mount Plate 1
A 14-291-04 Tank Bracket 2
B 14-284-02 Cap Assembly 1
C Blue Tube 1
D Clear Tube 1
E 14-291-03 Compressor Only 1
14-291-01 Black Cover 1
F 14-291-02 Foamer Tank 1
G 14-291-05 Double Switch Box 1
15-506-01 Fuse (F10A 250) 1
15-506-02 Switch 1
A-G 14-291 Foamer (includes parts A-G) 1
1. Position the mount plate on the back side of the roll bar using two 5/16 flange bolts. Install the brace by
removing the 1/2 bolt form the lefts side roll bar brace. reinstall the bolt, holding the two bracesto the roll
bar. Other end of foamer mount brace goes under the mount plate.
2. Place foamer unit onto mount plate, with cap facing to the left side of machine. Using 1/4 bolts and flange
nuts bolt foame marker to mount plate. the left rear moner mount of the foamer will oblt through the mount
plate and brace. Tighten all hardware.
3. Make sure all bolts are tightened.
CONNECTING THE CAP ASSEMBLY
Connect the blue tube to the tank cap connector which is also connected to the large blue tube which hangs
below the cap. This is the soap outlet tube. Connect the clear tube to the other connector on the tank cap. This
is the air input tube. Tighten connectors hand tight, assembly tank cap onto tank.
HOSES
Being careful not to cut the tubing, cut the oversleeve back approximately 2" (5 cm) to expose blue and clear
tubing. Remove blue wing nut from top connector of foam nozzle and slide it on the blue tube with the threads
facing toward end of tube. Slide blue tube all the way over the top of the small tube on foam nozzle. Slide wing
nut back to the threads and hand tighten. Follow the same steps for the clear tube and tube nut.
Route the tubing along underside of main frame using tie downs as necessary.
Install opposite ends of air-liquid tubes to compressor, again cutting back the oversleeve approximately 2" (5 cm)
and inserting blue and clear tubes for the left boom section into the tubing connectors on the right side of com-
pressor as far as possible. Follow the same steps for the right boom tubing. Notice the right boom is inserted
into left side of compressor. To release tubing from compressor, hold black ring around tubing, and pull tube out.