Smithco Spray Star 1000 (sn 100489 – 100523) Parts & Service Manual - Manual (Page 97)

95
Accessories
10-378 FOAM MARKER FOR 1000 PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 HB-14-20-075 Hex Bolt, 1 /
4
-20 x 3 /
4
4
HNFL-14-20 Flange Lock Nut, 1 /
4
-20 4
2 10-413 Foamer Brace 1
3 HB-12-13-150 Flange Bolt, 5 /
16
-18 x 1 1 /
2
1
4 HBFL-516-18-075 Flange Bolt, 5 /
16
-18 x 3 /
4
2
5 10-409 Mount Plate 1
A 14-291-04 Tank Bracket 2
B 14-284-02 Cap Assembly 1
C Blue Tube 1
D Clear Tube 1
E 14-291-03 Compressor Only 1
14-291-01 Black Cover 1
F 14-291-02 Foamer Tank 1
G 14-291-05 Double Switch Box 1
33-508 Fuse 1
15-506-02 Switch 1
A-G 14-291 Foamer (includes parts A-G) 1
Safety: Before working on machine stop engine, set park brake, remove key from ignition and block
wheels. Disconnect negative (-) battery terminal.
1. Mount the switch box on the side control panel facing towards the seat using the two wing nuts that came
with the switch box.
2. Connect the compressor to the switch box.
WIRING
Use dielectric grease on all electrical connections. Connect power cable (15-509) to the switch box. Turn the
switch off. Route the power wire to the fuse block (on the inside of the engine cover) out of the way of any heat
or moving parts. Use nylon ties as needed. Cut the power wire with enough length to connect the fuse block. Put
the slide on terminal with heat shrink onto the wire ends and connect to fuse block. Red to positive(+), black to
negative(-). Insert 10 amp fuse into slot which has red wire attached to it.
FOAM MARKER WIRING PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 14-291-03 Compressor 1
2 15-504-04 Wiring Harness 1
3 14-291-05 Switch Box 1
33-508 Fuse 1
15-506-02 Switch - Center 1
14-291-14 Switch - outside 1
4 15-509 Power Cable 1
5 33-271 Fuse Block (part of machine) 1
33-508 Auto Blade Type Fuse 1