Wiring diagram, Operation, Lighting instructions – Design Dynamics DVF-36S-N User Manual
Page 21: For your safety read before lighting
www.desatech.com
120441-01A
21
WirinG DiAGrAM
EV2
EV1
ORANGE
IGNITOR LEAD
GREEN
PILOT
TRANSFORMER
IS1070
B
SYNETEK CONTROLS IN
C
24V
AC
E4
E2
E3
E6
RED
E8
E12
BLUE
120V
AC
GROUND
120
VAC
ADAPTER/
REMOTE
RECEIVER
J-BOX
BLACK
WHITE
OPerAtiOn
C. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation
of new fireplace, burning logs
will give off a paper-burning
smell. Orange flame will also
be present. Open damper or
window to vent smell. This will
only last a few hours.
1. STOP! Read the safety information
above.
2. Turn off all electric power to the
fireplace.
3. Turn wall switch to the OFF position.
4. Remove center brick/control cover.
5. Turn equipment shutoff valve clock-
wise
to the OFF position (see
Figure 34, page 22). Do not force.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance is equipped with an igni-
tion device which automatically lights
the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.