Delta Faucet NANOTRACE DF-745 - Manual (Page 3)

Read Me First…
Unpacking Procedure
Follow the procedure below to unpack your NanoTrace Moisture Analyzer
1. Examine the condition of the packaging and its contents. If any damage is
apparent, immediately notify the carrier and Delta F. Do not proceed with
the installation.
2. Check the contents against the packing slip to make sure the shipment is
complete. Unattached equipment may be shipped with the analyzer in
supplemental packaging. Shortages should be reported to Delta F
immediately.
3. All NanoTrace Moisture Analyzers are shipped with the following:
Item Delta F Part
Number
Power cord with 115 VAC connector
NOTE: No power cord is supplied with 220 VAC units
P/N 59017237
USB Memory Stick, Flash Drive (SONY USM512J) P/N 49600512
VCR Filter Gasket P/N 60300268
Aspirator P/N 14241410
Instruction Manual P/N 99000041
4. Open the analyzer door, remove any shipping materials and verify that
nothing has come loose during transit.
5. The analyzer is set at the factory to operate on 120 VAC or 240 VAC.
Examine the voltage indicator on the rear panel to verify that the voltage is
set as ordered.
6. Save the original container in the event you may need to ship the analyzer
to another location or back to the factory (see Shipping in the Service
section).
Installation and Maintenance
The NanoTrace Moisture Analyzer provides years of accurate and dependable
service if it is set up, operated and maintained properly. It is essential to make
a careful and complete installation as outlined in the Installation and Start Up
section of this manual. It is assumed that NanoTrace Moisture Analyzer users
are familiar with the techniques and precautions associated with Ultra-High
Purity (UHP) gas, its plumbing, and devices such as UHP regulators and gas
purifiers, and that the analyzer is used as designed and intended.