SIGMA DP3 Merrill - Manual (Page 75)

74
1
Select [ Capture Settings] (P.28) → [Auto Bracketing] →
[Bracketing Amount], and press the button or the button.
2
Use the buttons to set the bracketing amount.
●
It can be set in 1/3 stop increments up to ±3
3
Press the button to confirm, press the shutter button
‘‘half-way’’ to return to shooting mode. (The Auto
Bracketing icon will be displayed on the bottom right
corner of the LCD monitor.)
■
The camera will take three pictures in the following sequence;
Appropriate exposure, under exposure and over exposure.
■
The operations in each Drive Mode are shown below.
Single Capture
Each time the shutter button is pressed, an image
will be taken one frame at a time.
Continuous
Three frames will be taken continuously by pressing
and holding the shutter button.
Self Timer
2 sec.
2 seconds after pressing the shutter button, three
frames will be taken continuously.
Self Timer
10 sec.
10 seconds after pressing the shutter button, three
frames will be taken continuously.
Infinite Shooting
While holding down the shutter button, three frames
will be taken continuously and repeated.

This function cannot be used with the interval timer shooting.
■
The exposure bracketing can be used with 4 different modes.
P Mode Both shutter speed and aperture value will be changed.
A Mode Only shutter speed will be changed.
S Mode Only aperture value will be changed.
M Mode Only shutter speed will be changed.