Sierra Video Yosemite - Manual (Page 91)

SPECIFICATIONS
85
An input number of 0 means the output connection is to be left unchanged.
An input number of ë-ë (dash) means the output is to be disconnected. If the router does not
support disconnected outputs, the output connection will be left unchanged.
Any input or (implied) output number may be specified as long as it exists on at least one level.
No connection will be made on any level on which an input or (implied) output number does not
exist. If the requested connection has an output or input number that isn’t mapped to a physical
connector (on virtual-mapped routers) on one or more levels, those levels are simply not
changed.
If “U2” is in effect (see “U” command), the response will include one or more V, Y, or X
commands to report the new status of the outputs. The response will be the same as if “O”
commands were issued for the outputs immediately following the “Z” command. No response is
generated if this command is being used to define a salvo.
“D”: Delay vertical sync intervals
The command "D" is used to delay before continuing execution of the commands that follow. It
must be followed by a number giving the number of vertical sync intervals by which to delay. If the
number is 1, the delay will be to the VERY NEXT vertical sync interval. If the number is 0, no
delay occurs. The number must be no larger than 255. Note that this command will also delay the
time at which the remaining command responses and the trailer character are returned to the
host.
For example, the command:
** Y1,5 D200 D100 Y1,6 S !!
says that input 5 is to be connected to output 1 on all levels, then a delay of 300 (=200+100) sync
intervals is to occur, then input 6 is to be connected to output 1 on all levels, then a status
response is to be returned.
It is generally recommended that the host computer be responsible for timing the initiation of
commands, rather than using this command to do the job. The host computer can simply send
the appropriate commands at the appropriate times. The "P" and "T" commands described below
can aid in ensuring that lengthy connect sequences aren't delayed due to the time it takes to send
them to the router.
“T”: Trigger a Salvo
The command "T" is used to trigger a previously set up salvo (set using the "P" command above).
It must be followed by a register letter from A to Z or a register number from 1 to 256 giving the
register to be triggered.
For example, the command:
** TB D180 TC !!
says to trigger salvo register B (same as 2), delay 180 sync intervals, then trigger salvo register C
(same as 3). When the register is triggered, this means that the connect commands stored in it
take effect.
If a salvo is triggered and it attempts to connect a locked output or port, or a disallowed
input/output pair, or a port to itself, the salvo trigger operation is aborted, no crosspoint changes
are performed, and an error is reported: “ERROR Salvo Has Locked Xpts”.