Sierra Video Yosemite User Manual
Page 65
SIERRA VIDEO
59
505150 Processors
Introduction
Two types of control processors can be used to control the Yosemite routing switcher. The Sierra video
505050 module is the most popular in the Yosemite line. This control processor is installed in a video
frame and can control the routers interconnected to the video frame.
If Yosemite Family video frames are not ordered in a system, a Sierra video 504001 Tahoe controller
module is installed in one of the audio frames. All Yosemite audio frames have a module position pre-
wired for a 504001 processor. Refer to the next chapter: 504001 Processors
For smaller systems with dual processor requirements, a 1RU Dual Processor unit may be used
(805151). Examples of this are a 64x64 video frame with restricted area or audio frames. This 1RU
processor frame may be used with any Yosemite or Tahoe-compatible routing switcher and acts as the
processing unit, eliminating the processors from the main frames.
Dual or single processors can also be mounted outside of the Yosemite video and audio frames in the 1
rack unit (1.75”) processor frame. This 1RU processor frame is connected to either video or audio frames
via a 25-conductor cable using the parallel control port.
Chapter
6
Yosemite 505150 Control
Processor Module