Warnings, Cautions, Cautions (continued) – Sierra Video Yosemite User Manual
Page 8

SIERRA VIDEO
2
Any instructions in this manual that require opening the equipment cover or enclosure are
intended for use by qualified service personnel only. To reduce the risk of electrical shock, do not
perform any servicing other than what is contained in the operating instructions unless you are
qualified.
Warnings
Heed all warnings on the unit and in the operating instructions.
Disconnect AC power before installing any options.
Do not use this product in or near water.
This product is grounded through the grounding conductor of the
power cord. To avoid electrical shock, plug the power cord into a
properly wired receptacle before connecting inputs and outputs.
Route power cords and other cables so that they are not likely to be
damaged, or create a hazard.
Dangerous voltages exist at several points in this product. To avoid
personal injury, do not touch unsafe connections and components
when the power is on.
To avoid fire hazard, use only the specified type, correct voltage, and
current rating of fuse. Always refer fuse replacement to qualified
service personnel.
Have qualified personnel perform safety checks after any completed
service
This is an FCC class A product. In a domestic environment, this
product may cause radio interference, in which case the user may be
required to take necessary measures.
Cautions
Use the proper AC voltage to supply power to the switcher. When
installing equipment, do not attach the power cord to building
surfaces.
To prevent damage to equipment when replacing fuses, locate and
correct trouble that caused the fuse to blow before applying power.
Use only the recommended interconnect cables to connect the
switcher to other frames.
Follow static precautions at all times when handling the equipment.
Cautions (continued)
Power this product only as described in the installation section of this
manual.
Leave the side, top, and bottom of the frame clear for air convection
cooling and to allow room for cabling. Slot and openings in the
frame are provided for ventilation and should not be blocked.