Sierra Video View MADI-XX - Manual (Page 33)

SIERRA VIDEO
27
Installation
The Sierra View MADI-xx 1U frame may be installed in 19 inch bays with 355mm depth
(~400mm including connectors). Ventilation is produced in each frame with three exhaust fans on
the left hand side (viewed from front) with intake grilles at the right.
Frames should be installed into bays such that airflow through these apertures is not impeded.
Note: The front rack ears are intended to provide a means of retaining the unit in the rack.
To ensure adequate support the unit MUST also be supported at the rear of the frame. Please ensure
that ventilation is not impaired when selecting suitable supports.
Power and fuses
The mains voltage (240/100 volts) will be auto detected provided it is in the range 100 – 250 V and 47
– 63Hz, 50W. The unit uses a 1A fuse
Note: A spare 1A fuse should be located under the pull-out flap.
Chapter 3