Sierra Video 3232HD-3G - Manual (Page 62)

SIERRA VIDEO
52
Commonly Used Switching Commands
This section contains the most commonly used switching commands. These commands are
explained in detail in the proceeding.
“Y” Command- All Levels
The “Y” command switches all levels (i.e. video and audio).
For example;
**Y2,8!!
This requests that input 8 be connected to output 2 on all levels.
“X” Command- Specify Levels
Using the “X” command requires that a level is specified.
For example;
**X8, 3, 2!!
This requests that a connection is to be made between output 8 and input 3 on level 2. If a
level number of “0” is used, all levels are switched.
“V” Command- Connect Levels
The “V” command is followed by an output number, a comma, and an input number for each
level, up to the number of levels on the routing switcher.
For example;
**V12, 7, 8, 9!!
This requests that connections are to be made to output 12 from input 7 on level 1, input 8 on
level 2, and input 9 on level 3.