Sierra Video 3232HD-3G - Manual (Page 46)

SIERRA VIDEO
36
Source based Switching
1. Select an input
2. Select (enable level) to be switched by toggling the “A” and “V” button.
3. Select an output (. In auto take mode, the switch will occur immediately)
4. If auto take mode is not enabled the “Take” button will blink RED- press take to initiate
the switch, or you can select additional outputs to preset takes for multiple outputs to the
same selected source. In the latter case all selected outputs will be switched to the
selected source when take is pressed.
Source based Status
When an input is selected, the output(s) currently connected to that input will light.
Selected input button will be GREEN.
Output button colors:
CYAN to indicate video and audio.
GREEN to indicate video only.
BLUE to indicate audio only.
Lock
The LOCK button has 4 modes of operation. The mode can be set via the web pages.
The four modes are:
 Panel cannot be locked. Lock button is disabled and is always off.
 Panel can be locked. Lock button is enabled. It goes on/off when pressed. The
button will be RED when it is on. This is the default mode of operation.
 Panel always locked, show status. Lock button disabled and is always on. The
button will be PURPLE. Output buttons can be selected and input status is
shown.
 Panel always locked, do not show status. Lock button disabled and is always on.
The button will be PURPLE. All other buttons on the panel are always off.
If the panel is set to destintion based switching and the routing switcher status is allowed
while in the panel lock mode (see above), the user can select any output button. The
current Input connected to this output will status by illuminating.
While the panel is locked:
• The INPUT buttons will be disabled (nothing will happen when they are pressed).
If the panel is set to source based switching and the routing switcher status is allowed
while in the panel lock mode (see above), the user can select any input button. The
current output(s) connected to this input will status by illuminating.
While the panel is locked:
• The OUTPUT buttons will be disabled (nothing will happen when they are pressed).
In either mode,
• The following buttons will be off and disabled (nothing will happen when they are
pressed):
• FUNC button
• A button
• V button
• TAKE button