Sierra Video 3232HD-3G - Manual (Page 22)

SIERRA VIDEO
12
Salvos
Overview
A Salvo is a list of crosspoint switches that are saved in the routing switcher and switched
by a single “Salvo Take” command or from a salvo button on the front panel.
Up to 16 Salvos are stored in the routing switcher.
To make and name salvos, select the “Salvo” tab.
Salvo Setup
To program a salvo, select a salvo number from the dropdown list. This number is the
input button number, on the front panel, where the salvo will be stored and fired.
Enter a name (not required).
Enter the desired Input/Output combinations.
Select an “Action” (“Take” switches the selected layer and “Take All” switches all layers).
Click on the “Add Above” or “Add Below” button (“Add Above will put the entry on the top
of the list and “Add Below will put the entry at the bottom of the list).
Each salvo has a maximum of 32 steps/actions on the Aspen 3232-HD and 16 on the
Aspen 1616-3G.
The “refresh” button will re-read the current salvos in the routing switcher.
Make any changes necessary and press “Save Salvo” to program the Salvo.