Scotsman RS100 - Manual (Page 3)

FOR THE INSTALLER: Installation Of Loose Shipped Parts
Drip Tray/Grill
1. Remove splash panel from unit.
2. Place a worm drive clamp over the drain tube as
shown.
3. Hold drip tray at an angle of approximately 30
0
.
Hold flexible drain tube between two
fingers with other hand and push drip
tray drain fitting into the tube.
4. Check that the drain tubing is in place, and
tighten the hose clamp.
5. Hang the drip tray onto the metal tabs on the
base of the unit.
6. Replace the splash panel.
Ice lever/Ice Chute/Fluorescent Tube*
1. Pull out and remove upper front panel.
2. Slide out ice chute mounting panel.
3. Insert the ice lever in to the valve panel through
the slot as shown.
4. Swing the ice lever through from right to left and
let it hang freely.
5. Twist the fluorescent tube into the sockets.
6. Replace ice chute mounting panel.
7. Insert clear ice chute into the panel and twist
clockwise 1/3 turn.
8. Replace the upper front panel.
* Optional depending on unit configuration.
DRAIN TUBING
DRAIN
FITTING
DRIP TRAY
SPLASH
PANEL
DRIP TRAY
DRAIN
TUBING
MOUNTING TABS
ICE LEVER
HOSE
CLAMP
SIDE VIEW OF DRIP TRAY INSTALLATION
ICE CHUTE
ICE
CHUTE
MOUNTING
PANEL
RS100 and RS150
October 1993
Page 3