Scotsman RS100 - Manual (Page 2)

SPECIFICATIONS
The term “Refreshment Stand” means a machine
that stores ice in an insulated, sanitary container;
upon demand it dispenses that ice into a cup or
glass; it cools beverages using ice falling from the
hopper onto a cold plate below the hopper; and it
dispenses beverages via post-mix or pre mix
valves. One of the valves (2nd from left) is not
carbonated; it may be changed to carbonated if
desired. Power to operate the valves may be shut
off by a key switch.*
An important feature of this dispenser is that the
ice on the cold plate is not dispensed.
* Premix is not electrically powered.
The RS requires additional equipment to be
functional:
An ice machine or source of sanitary ice; a
carbonator for post mix (and potable water); a
syrup delivery system, either pressurized syrup
cans or bag-in-a-box; and CO
2
. The dispenser
must also be connected to a drain.
NOTE: This Refreshment Stand is designed to
dispense cubed or Nugget ice only. Flaked ice will
not work.
Base
Model Dimensions Storage
Capacity Basic Electrical Amperage Power Cord
RS100B 22"w x 30"d x 34"h 125 lbs. 115/60/1 2 amps 4’ with plug
RS150B 30"w x 30"d x 34"h 165 lbs. 115/60/1 2 amps 4’ with plug
Rotor motor is 1/10 H.P.
Options: Lighted upper front panel. 4" leg kit. Fast flow carbonator (100 G.P.H.). Push button actuation
(factory installed). Standard or fast flow Booth, Cornelius, McCann or Dole valves. Also available in premix
with Booth Capre valves only.
Scotsman Drink Systems are designed and manufactured with the highest regard for safety and
performance. They meet or exceed the standards of U.L., N.S.F., and C.S.A.
Scotsman assumes no liability or responsibility of any kind for products manufactured by Scotsman that
have been altered in any way, including the use of any parts and/or other components not specifically
approved by Scotsman
Scotsman reserves the right to make design changes and/or improvements at any time. Specifications and
designs are subject to change without notice.
RS100 and RS150
October 1993
Page 2