Scotsman MCM1062R - Manual (Page 28)

REMOVAL AND REPLACEMENT
//////////////////////////////WARNING//////////////////////////////////
Disconnect electrical power before beginning.
//////////////////////////////////////////////////////////////////////////////////
Water Pump
1. Remove front panel.
2. Remove evaporator cover.
3. Unplug water pump electrical connection.
4. Remove thumb screw retaining pump to cross
brace.
5. Pull pump partially out of reservoir and remove
discharge hose.
6. Remove two nuts holding pump cover to pump
body; separate the two and remove the pump from
the icemaker.
7. Reverse to reassemble.
8. Replace all panels.
9. Reconnect electrical power.
Inlet Water Solenoid Valve Assembly
To remove the inlet water solenoid valve assembly:
1. Shut OFF water supply to machine.
2. Loosen and remove outlet water line from the
inlet water solenoid valve assembly.
3. Remove screws and pull the water solenoid
valve out to gain access.
4. Pull electrical cord from solenoid coil terminals.
5. Remove inlet water fitting from the water
solenoid valve. To replace the inlet water valve
assembly, reverse the removal procedures.
ELECTRICAL
CONNECTION
WATER
PUMP
DISCHARGE
HOSE
REMOVAL OF THE WATER PUMP
ELECTRICAL
CORD
INLET WATER
SOLENOID
OUTLET
TUBE
REMOVAL OF INLET WATER SOLENOID VALVE
MCM1062R
October 1993
Page 28