beautypg.com

For the electrician, Mcm1062r, For the electrician: electrical connections – Scotsman MCM1062R User Manual

Page 10

background image

FOR THE ELECTRICIAN: Electrical Connections

See the NAMEPLATE for current requirements to
determine wire size to be used for electrical
hookup. The cuber requires a solid chassis to
chassis earth ground wire. See Wiring Diagram.

Be certain the cuber is connected to its own
electrical circuit and individually fused. Voltage
variation should not exceed ten percent of the
nameplate rating, even under starting conditions.
Low voltages can cause erratic operation and may
be responsible for serious damage to the
icemaker.

Electrical connections are made at the rear of the
icemaker, inside the junction box.

/////////////////////////////CAUTION///////////////////////////////

Do not switch the ice maker on at this time, make
certain the master and compressor switches are
OFF when power is connected to the icemaker.
Power must be connected to the ice maker long
enough in advance of start up to allow the
crankcase heater to warm the compressor, usually
about 12 hours.

//////////////////////////////////////////////////////////////////////////////

Scotsman Condenser:

Separate electrical connections are made from the
ice maker to the condenser, as there is line power
interconnecting the icemaker to the condenser.

All external wiring should conform to the
national, state and local electrical code
requirements. Usually an electrical permit and
services of a licensed electrician will be
required.

REMOTE CONDENSER ELECTRICAL

CONNECTION (SCOTSMAN CONDENSER)

POWER SUPPLY TO

REMOTE SCOTSMAN

CONDENSER

POWER SUPPLY

TO ICE MAKER

TERMINAL STRIPS

MCM1062R

October 1993

Page 10

This manual is related to the following products: