Scotsman CS0415 - Manual (Page 19)

Removal and Replacement - Thermistor
Bin Thermistor and / Or Cutter Grid
1. Unplug ice maker or disconnect power.
2. Open the ice maker door.
3. Cover or remove the ice from the storage bin.
4. Place a cloth in the drain hole to avoid hardware
from falling inside.
5. Remove the two hex-head screws from the
cutter grid cover and remove the cover.
6. To remove the bin thermistor:
a) Disconnect the bin thermistor connector from the
bottom of the control housing.
b) Pull the bin thermistor out of the retaining clamp
and remove it.
7. To remove the cutter grid:
a) Disconnect the cutter grid and bin thermistor
connectors from the bottom of the control housing.
b) Remove the two hex-head screws from both
sides of the cutter grid. The longer screw and white
spacer are on the right side.
Slide the cutter grid forward and out of the unit and
place it on a work surface.
Be careful not to scratch the ice maker liner.
d) Remove the spacer from the right cutter grid
bracket tab.
Unsnap the two ice guides from the cutter grid
tabs. There should be a slight outward tilt after the
guides are installed. Bend the metal tabs outward if
necessary.
July 2007
Page 19
CS0415
Service Manual
Electrical Shock Hazard
Electrical shock can
cause personal injury.
Disconnect electrical
power before proceeding.
Cutter Grid
Control Housing
Connector
Bin Thermostat
Cutter Grid
Connector
Cutter Grid
Screws