Scotsman CME1356R - Manual (Page 2)

Specifications
Both of these ice machines are designed to be
installed indoors, in a controlled environment.
They can operate satisfactorily under a wide
variety of conditions. However, Do NOT operate
the machine in temperatures it has not been
designed for. Do NOT operate the machine above
or below the voltage limits for the particular model.
Do NOT operate the machine with too little or too
much water pressure.
Operational Limits
Minimum Maximum
Air Temperature 50oF. 100oF.
Water Temperature 40oF. 100oF.
Water Pressure 20 psi 80 psi
Voltage (60 Hz) 197 253
Voltage (50 Hz) 207 253
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specifications and designs are subject to change
without notice.
Scotsman assumes no liability or responsibility
of any kind for products manufactured by
Scotsman that have been altered in any way,
including the use of any parts and/or other
components not specifically approved by
Scotsman.
Bins:
All models will fit a standard, 48" wide or wider
open top Scotsman Ice Storage Bin. Some
examples are:
·
BH900
·
BH1366
·
BH1666
In addition, there may be other bins that can be
used, check Scotsman’s sales literature for
application information.
Note: Slope-front bins must have an internal baffle.
Scotsman’s BH900 has the required baffle. Baffle
must be approximately in the position shown in the
diagram below.
CME1356R and CME1656R
March 2010
Page 2
Model Number Dimensions
W x D x H
(w/o bin)
Basic Electrical
(volts/Hz/phase) Use
Condenser Refrigerant
Charge
R-404A Minimum
Circuit
Ampacity Max
Fuse
Size
CME1356RS-32H 48 ½ “ x 24" x 28 208-230/60/1 ECR411-32A 288 oz 24.9 30
CME1356RS-3H same 208-230/60/3 ECR411-32A 288 oz 15.9 20
CME1356RS-6H same 230/50/1 ERC411-32A 288 oz 24.9 30
CME1656RS-32H same 208-230/60/1 ECR411-32A 288 oz 24.9 30
CME1656RS-3H same 208-230/60/3 ECR411-32A 288 oz 15.9 20
CME1656RS-6H same 230/50/1 ECR411-32A 288 oz 24.9 30
* The remote condenser is designed to work in temperatures from -20
o
F. to 120
o
F.
Use precharged tubing kits, RTE25 (25’) or RTE40 (40’) or RTE75 (75’). Select the length closest to the
needs of the particular installation.
The stacking kit required to place two like model cubers together is: KSCME6-LG-B. The kit required to
connect this ice machine to a central condenser is: RCKCME6GX
BASIC INFORMATION
12.0"
4.0"
Side View
Baffle