Denon AVR-987 - Manual (Page 66)

62
Operating the remote control unit
Operating the remote control unit
Operating DENON audio components
Set [MODE1] to “AUDIO”.
• It may not be possible to use some of the buttons, depending
on the model and age of your equipment.
1
Set [MODE2] to the position for the component to
be operated (CD, CD-R/MD or TAPE).
2
[MODE1] [MODE2]
Setting the preset memory function
• DENON and other makes of components can be operated by
setting the preset memory.
• This remote control unit can be used to operate components of
other manufacturers without using the learning function by
registering the manufacturer of the component as shown in the
list of preset codes (
End of this manual).
• Operation is not possible for some models.
Operate the audio component.
For details, refer to the component’s operating instructions.
While this remote control is compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot be operated with this remote
control.
3
Set [MODE1] to “AUDIO” or “VIDEO”. 1
Set [MODE2] to the component to be registered. 2
Set to the AUDIO side for the CD, TAPE or CD-R/MD
position, and to the VIDEO side for the DVD/VDP,
DBS/CABLE, VCR or TV position.
Press [ZONE2 OFF] and [ZONE1 (MAIN) ON] at
the same time.
• The indicator starts flashing.
3
Referring to the included list of preset codes,
press
[NUMBER] to input the preset code (a 3-
digit number) for the manufacturer of the
component whose signals you want to store in the
memory.
4
To store the codes of another component in the
memory, repeat steps 1 to 4. 5
• The signals for the pressed buttons are emitted while setting
the preset memory. To avoid accidental operation, cover the
remote control unit’s transmitting window while setting the
preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes
listed in the list of preset codes.
• Some manufacturers use more than one type of remote control
code. Refer to the included list of preset codes to change the
number and verify correct operation.
• The preset memory can be set for one component only among
the following: CD-R/MD, DVD/VDP and DBS/CABLE.
[ZONE1 (MAIN) ON]
[NUMBER]
[ZONE2 OFF]