Denon AVR-987 - Manual (Page 56)

52
Advanced Setup – Part 1 Advanced Setup – Part 1
Setting the On Screen Display (OSD)
Set whether or not to display the on screen display for indications
other than the menu screens.
Press D D H H to select “On Screen Display”, then
press ENTER .
Press D D H H to select the item, then press F F G G to
set.
Function/Mode Status:
• ON, OFF:
Select “ON” to display the on screen display when the input
source is selected, “OFF” if you do not want to display it.
Master Volume Status:
• ON, OFF:
Select “ON” to display the on screen display when the main
volume is adjusted, “OFF” if you do not want to display it.
Display Mode:
• Mode 1:
Flickering is not prevented.
• Mode 2:
Prevents flickering of the on screen display when there is no
video signal.
Use this mode if the on screen display is not displayed in
“Mode1”.
Press ENTER .
1
2
3
1
2
Advanced Playback
Setting the 2ch Direct/Stereo
Make the 2-channel direct mode and stereo mode speaker
settings.
Press D D H H to select “Advanced Playback”, then
press ENTER .
Press D D H H to select “2ch Direct / Stereo”, then
press ENTER .
• The current settings are displayed.
1
2
3
Press D D H H to select the item, then press F F G G to
set.
Large:
Select this when using large speakers with ample low
frequency reproduction capabilities.
Small:
Select this when using small speakers without ample low
frequency reproduction capabilities.
Yes, No:
Select “Yes” when a subwoofer is connected, “No” when no
subwoofer is connected.
4
LFE:
For any channel(s) that are set to “Large”, low frequencies in
that channel’s corresponding source are directed to that
loudspeaker only. The low frequencies played from the
subwoofer are only the LFE signals and the low frequencies
of channels set to “Small”.
LFE+Main:
Low frequencies from speaker channels that have been set to
“Large” are reproduced from those speakers as well as from
the subwoofer(s).
Press ENTER . 5
Press F F G G to select “Custom”.
1
2
3
4