Denon AVR-987 - Manual (Page 59)

55
Advanced Setup – Part 1 Advanced Setup – Part 1
Setting the Volume Control
This sets the volume level of output.
Press D D H H to select “Volume Control”, then press
ENTER .
Press D D H H to select the item, then press F F G G to
set.
Vol. Limit:
Set the volume’s upper limit.
• OFF:
If you do not want to set a volume limit, select “OFF”.
In this case, the volume can be set to the AVR-987’s
maximum volume (output) level of +18 dB, which is
extremely loud.
• –20 dB, –10 dB, 0 dB:
The volume cannot be increased above the selected levels.
1
2
Mute Lev.:
Set the level of volume attenuation in the mute mode.
• FULL
The volume is fully muted.
• –20 dB, –40 dB
The volume is lowered 20 dB (or 40 dB) from the current level.
P. On Lev.:
Set the volume level when the power is turned on.
You can adjust the MAIN ZONE volume level within the range
of –80 to +18 dB (and ZONE2 volume level within the range
of –70 to +18 dB).
• LAST
The volume set when the AVR-987 was last used is stored in
the memory and set when the power is turned on.
• – – – (Mute)
The volume is always muted when the power is turned on.
• When the power amplifier is assigned to either of the ZONE2
channels at “Power Amp Assign”, “–VAR–” (only variable) is
displayed and the fixed level cannot be set.
Press ENTER . 3
1
2
Setting the Trigger Out
Press D D H H to select “Trigger Out”, then press
ENTER .
Press F F G G to select “MAIN” or “ZONE2”.
The power supplied from the trigger out jack turns on and off
when the power for the set zone is turned on and off.
Press D D H H to select the trigger out jacks, then
press ENTER .
Use the DC12V output of the AVR-987’s 2 trigger out jacks in
association with the various input sources and surround modes.
If “ZONE = MAIN” is selected, settings can be made for the
individual surround modes.
Press D D H H to select the input source, then press F F
G G to set.
ON, OFF:
When that input source is selected, the power supplied from
the trigger out jack turns on (or off).
1
2
3
4
Press ENTER .
When “MAIN” was selected at step 3:
Press
D D H H to select the surround mode, then
press F F G G to set.
ON:
If “ON” is selected when an input source set to “ON” is
selected, the power supplied from the trigger out jack turns
on.
OFF:
If “OFF” is selected when an input source set to “ON” is
selected, the power supplied from the trigger out jack turns
off.
5
6
1
2
3
4
5