Denon AVR-987 - Manual (Page 28)

24
Basic Operation Basic Operation
Selecting the room equalizer mode
The room equalizer function offers 3 correction curves:
“Audyssey”, “Front” and “Flat”. These modes can be selected
after performing the auto setup procedure.
OFF Audyssey Front Flat Manual
Press ROOM EQ .
• The “MultEQ XT” indicator lights green when “Audyssey” is
selected, red when “Front” or “Flat” is selected.
The indicator lights red if the speaker settings are changed
after the auto setup measurements have been made (
page 56 ~ 59).
Audyssey, Front, Flat:
See page 60.
Manual:
Selects the setting value that was set in the Manual Equalizer
Setup (
page 53, 54).
Turning the sound off temporarily (MUTING)
Press [MUTING] .
You can adjust the muting level ( page 55).
• Canceling MUTING mode:
To cancel the muting mode, either press [MUTING] or adjust the
volume.
Connect the headphones to .
• No sound is produced from the speakers automatically.
NOTE:
• To prevent hearing loss, be careful not to raise the volume
level excessively when using headphones.
Listening over headphones
Switching the front speakers
Press [SPEAKER] .
FRONT A
FRONT A+B
FRONT B
2 On screen display
Checking the currently playing program
source, etc.
Press [ON SCREEN] .
• The current program source and various settings are
displayed on the monitor screen.
2 Front panel display
Press .
• The current program source and various settings are indicated
on the display.
Switching the brightness of the display
Press .
The brightness of the display can be adjusted in 3 steps. The
display can also be turned off.
SURROUND
PARAMETER
ROOM EQ
DIRECT/STEREO
PURE DIRECT
[ON SCREEN]
[MUTING]
ROOM EQ
[SPEAKER]
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
SURROUND
PARAMETER
PURE DIRECT DIRECT/
STEREO