Connecting the multi zone terminals, Zone2 out connections, Connecting the trigger out jacks – Denon AVR-987 User Manual
Page 25: Connecting the rs-232c terminal, Connecting the ipod
21
Connecting Other Sources
Connecting Other Sources
For instructions on operations using the MULTI ZONE functions (
page 40, 41).
Connecting the MULTI ZONE terminals
• If another pre-main (integrated) amplifier is connected, the ZONE2 out (fixed level) terminals can
be used to play a different program source in ZONE2 the same time (
page 40).
ZONE2 out connections
• For the AUDIO output, use high quality pin-plug cables and wire in such a way that there is no
humming or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices’
operating instructions.
Monitor
(ZONE2)
S-VIDEO
IN
VIDEO
IN
AUX OUT
Premain amplifier
(ZONE2)
R
L
IN
G
F
R
L
R
L
A
+
+
Extension terminal
for future use.
Input
Output
RC-616
Infrared retransmitter
RC-617
Infrared sensor
Connecting the TRIGGER OUT jacks
Turn the DC 12 V voltage on and off for
the individual functions and surround
modes.
For details, see “Setting the Trigger Out”
(
page 55).
Connecting the RS-232C terminal
This is a control expansion terminal for
factory use only. Consult you dealer for
details.
Perform the following operation before
using an external controller connected to
the RS-232C terminal:
1. Press the ON/STANDBY button on the
main unit and set the unit to the
operating mode.
2. Perform the operation to turn off the
power from the external control.
3. Check that the product has been set
to the standby mode.
After checking the above, check the
connections of the external controller.
Operation is possible.
Connecting the iPod
®
iPod
L
R
L
R
A
G
AUDIO OUT
S-VIDEO OUT
ASD-1R
When using an iPod, you must Connect the DENON original Control Dock for iPod and the DOCK
CONTROL jack on the AVR-987 with a mini-jack and assign the iPod to any AUDIO and/or S-VIDEO
terminal(s).
The diagram below shows an example of connections for when the iPod is assigned to the VDP
terminal.
For instructions on assigning the iPod to a specific terminal, see
“Setting the iPod Assignment” (
page 47).
For instructions on playing the iPod, see “Playing the iPod” (
page 39).
• The optional standard Control Dock for iPod is DENON ASD-1R sold separately.