Scotsman C1448R - Manual (Page 8)

C1448, C1848, C2148
Remote Condenser Models - User Manual
November 2006
Page 7
Panel Removal
1. Locate and loosen the two screws at the front
edge of the top panel.
2. Pull the front panel out at the top until it clears the
top panel.
3. Lift the front panel up and off the machine.
4. Remove two screws from the front edge of the top
panel.
5. Lift up the front of the top panel, push it back an
inch, then lift to remove.
6. Locate and loosen the screw holding each side
panel to the base.
7. Pull the side panel forward to release it from the
back panel.
This manual covers several models of remote cubers.
The model number on the ice machine can be found
either on the dataplate, which is on the back panel, or
the serial number tag, which is behind the front panel.
See the illustration for the locations of the dataplate
and the serial number tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on the
dataplate on the condenser near the quick connect
fittings.
Write the model and serial number of the ice machine
here:
Write the model and serial number of the remote
condenser here:
Write the model and serial number of the ice storage
bin here:
Write the day of initial start up here: That day starts
the warranty period.
Uncrate and Set Up
Begin with the ice storage bin. Remove the carton,
and, using part of the carton as a cushion, tip the bin
on its back to remove the skid. Attach the supplied
legs or optional casters. Return the bin to a normal,
upright position.
Check the bin top gasket for tears or gaps. If recycling
an older bin, replace the gasket or repair with food
grade sealant prior to placing the ice machine on the
bin.
Install the bin top adapter, if one is required for the
application.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Cut away any
shipping strapping. Lift the ice machine off the skid
directly onto the bin.
Note: The machine is heavy. Use a mechanical lift if
necessary.
Secure the ice machine to the bin with the hardware
provided (two metal straps and four bolts).
Panel Removal
5
1
6