beautypg.com

Scotsman C1448R User Manual

Page 23

background image

C1448, C1848, C2148

Remote Condenser Models - User Manual

November 2006

Page 22

13. Remove water distributors from ice machine.

Inspect each distributor for restricted orifice holes.

Be sure all holes are full open.

14. Locate ice thickness sensor. Squeeze mounting

legs together to release sensor. Wash the metal

surfaces of the sensor and the adjustment screw

with ice machine cleaner solution. Also wash the

water distributor and curtain with the ice machine

cleaner solution.

15. Locate water level sensor. Squeeze catches

together and pull up to remove sensor. Separate

probes from housing and wash all surfaces with

ice machine scale remover solution. Return

probes to holder.

16. Mix a solution of locally approved sanitizer. Use

an EPA approved food equipment sanitizer at

the solution mix recommended by the sanitizer

manufacturer.

Note; A possible sanitizing solution may be made by

mixing 1 packet of Stera Sheen Green Label sanitizer

(available from Scotsman) with 2 gallons of warm (95-

115

o

F.) potable water.

17. Thoroughly wash all surfaces of the ice thickness

sensor, water level sensor, curtain and water

distributor with the sanitizer solution.

18. Thoroughly wash all interior surfaces of the

freezing compartment, including evaporator

frames, back wall, evaporator cover and the

part of the top panel covering the freezing

compartment with the sanitizer solution.

19. Return water level sensor, ice thickness sensor,

water distributors and curtains to their normal

positions.

20. Push and release the clean button again and

when the purge valve indicator light goes out,

immediately pour the remaining cleaning solution

into the reservoir.

21. Circulate the sanitizer solution for 10 minutes,

then push and release the Clean button.

22. Allow the water system to be flushed of sanitizer

for at least 20 minutes, then push and release the

Off button.

23. Return the evaporator cover and front panel to

their normal position and secure with the original

fasteners.

24. Push and release the On button to resume ice

making.

Ice Storage Bin
Remove and discard all ice. Mix a solution of

Scotsman Clear 1 ice machine scale remover and

wash all interior surfaces of the ice storage bin to

remove any mineral scale build up. Pour excess

cleaner solution into the bin’s drain.

Mix a solution of sanitizer and thoroughly wash all

interior surfaces of the ice storage bin.

Inspect Orifice Holes

Holder

Squeeze tabs together, slide out until it stops, then lift

to remove.

March 2013

This manual is related to the following products: