Denon RCD-M37 - Manual (Page 7)

Connections
Set
up
Pla
ybac
k
Set
ting the
Timer
Other F
unctions
Tr
oubleshooting
ENGLISH
Specifications
Cautions on Handling
• Do not get fingerprints, oil or dirt on discs.
• Take special care not to scratch discs when removing them from
their cases.
• Do not bend or heat discs.
• Do not enlarge the hole at the center.
• Do not write on the labeled (printed) surface with ball-point pens,
pencils, etc., or stick new labels on discs.
• Water droplets may form on discs if they are moved suddenly from a
cold place (outdoors for example) to a warm place, but do not try to
dry them off using a hairdryer, etc.
Cautions on Storing Discs
• Be sure to remove discs after using them.
• Be sure to store discs in their cases to protect them from dust,
scratches, warping, etc.
• Do not store discs in the following places:
1. Places exposed to direct sunlight for long periods of time
2. Dusty or humid places
3. Places exposed to heat from heating appliances, etc.
Cleaning Discs
• If there are fingerprints or dirt on discs, wipe them off before using
the disc. Fingerprints and dirt can impair sound quality and cause
interruptions in playback.
• Use a commercially available disc cleaning set or a soft cloth to clean
discs.
Gently wipe the disc from the
inside towards the outside. Do not wipe with a circular
motion.
NOTE
Do not use record spray, antistatic agents, or benzene, thinner or other
solvents.
Cautions on Loading Discs
• Only load one disc at a time. Loading two or more discs can damage
the unit or scratch the discs.
• Do not use cracked or warped discs or discs that have been repaired
with adhesive, etc.
• Do not use discs on which the sticky part of cellophane tape or labels
is exposed or on which there are traces of where labels have been
removed. Such discs can get caught inside the player and damage
it.
Inserting the Batteries
q Slide the rear lid in the
direction of the arrow and
remove it.
w Load the two batteries properly
as indicated by the marks in the
battery compartment.
e Put the rear cover back on.
Figure 1
• “00 Tr 00 : 00” is displayed if a disc that cannot be played is loaded.
• “00 Tr 00 : 00” is displayed if the disc is loaded upside-down or if no
disc is loaded.
Do not touch the signal surface.
Holding Discs
• Set the disc with the labeled side facing up.
• Make sure the disc tray is fully open when inserting the disc.
• Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1), 8
cm discs in the inner tray guide (Figure 2).
Loading Discs
12 cm disc 8 cm disc
Outer tray guide Inner tray guide
Figure 2
• Place 8 cm discs in the inner tray guide without using an adapter.
NOTE
Do not push the disc tray in by hand when the power is turned off.
Doing so could damage the set.
Get
ting Star
ted
About the Remote Control Unit
NOTE
• Discs with special shapes (heart-shaped discs, octagonal discs, etc.)
cannot be played. Do not attempt to play them, as doing so can
damage the product.
• Some discs and some recording
formats may not be playable.
• Non-finalized discs cannot be
played.
b What is finalization?
Finalization is the process that
makes recorded CD-R/CD-RW discs playable on compatible
players.