Dolby Laboratories Multichannel Audio Tool DP570 - Manual (Page 75)

Dolby ® DP570 Multichannel Audio Tool User’s Manual 59
Appendix A
Configuring a Monitor System
Configuring the monitor system to establish a balance between all channels and to ensure
that all speakers play back at the correct level relative to the listening reference position is
a complex task that must be done correctly to achieve optimal results.
Four steps are required to set up your listening environment:
1. Assigning Monitor System Configuration Settings on page 59
2. Setting Delay Values on page 63
3. Calibrating Speaker Playback Levels on page 64
4. Assigning a Dim Setting on page 68
A.1 Assigning Monitor System Configuration Settings
Assigning these configurations consists of several steps:
1. Opening the Monitor Setup Tab on page 59
2. Selecting Analog Outputs on page 60
3. Choosing Bass Management Settings on page 60
4. Choosing Back Surround Speakers on page 62
5. Setting the Lt/Rt Gain on page 62
6. Configuring Dolby Pro Logic II on page 62
A.1.1 Opening the Monitor Setup Tab
All the adjustments for setting up the DP570 to match your monitoring equipment are
available on the Monitor tab of the Setup screen in the DolbyRemote 570 software. To
access this screen, click the Setup button on the main screen shown in
Figure A‐1 .
Figure A‐1
Figure A-1 Setup Button
The system displays the Setup window with the Monitor tab active, as shown in
Figure A‐2 .