Power indicator light is off or blinks, Signal indicator light is off or blinks, 12v power interface poor contact – RGBLink MSP 217 User Manual User Manual

Page 29

MSP 217 User Manual 29

1. Check whether plug in the power cord, and has power supply;

2. Check whether the power cable is connected, and in good

connection;

3. If above without problem, then the power indicator is damaged.

1. Check whether connect the signal;

2. Check whether the input signal, input wire and output wire are

normal, the interfaces are in good connection;

3. If above without problem, then the signal indicator is damaged.

Note: The indicator beside fiber interface is on when the device is in normal

operation. It will off or blink if the fiber cable is in poor connection.

1. Check whether the power interface is in good connection, if the interface

is not tighten, screw it again.

2. Check whether any problem with adapter head, replace it if there is any

problem.

3. Check the power connector is loose, if so, please send to processional

personnel for repair.