How to adjust the output resolution – RGBLink MVP 8043 Quick Start User Manual

Page 9

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

2. Rotate the knob, choose [Output], push the knob to confirm, and enter next level menu.

3. Choose [Program], and enter [Program Format], push the knob to confirm.

4. Choose the required output resolution, push the knob to confirm, and finish the choice of resolution.

User can also custom the resolutions according to actual need. And the operations are as follows:

1. Push MENU button to enter menu option.

2. Rotate the knob, choose [Output], push the knob to confirm, and enter next level menu.

3. Choose [Program], and enter [Program Custom Format], push the knob to confirm.

4. Turn knob on each bit position, and change the value of the bit by the digital buttons on the

front panel.

5. After the digital push knob will add ×, means before × is the horizontal size. Same operation

for vertical size.

6. After the digital push knob will add @, means before @ is the vertical size. Same operation

by push digital buttons to set the refresh rate.

8. After input all the values, push knob to enable MVP 8043 to output this resolution. MVP 8043

will take 5 to 10 seconds to enable this output resolution.