RGBLink MVP 8043 Quick Start - Manual (Page 10)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
9
How to Realize Signal Switching
1. Boot the system default DVI1 to the current input source (key lights).
2. If need switch to other source such as SDI1, push SDI1 button, key flashes, again push
TAKE button, SDI1 key lights, and switch SDI1 to Program output.
3. After choose SDI1 signal, the former button DVI1 flashes, and SDI1 key lights, it realize the
input signal switching (Switch input signal DVI1 to SDI1).
The same method can switch DVI2, DVI3, DVI4, SDI2, SDI3, SDI4.
How to Set up the Size and Position of Single Image
1. Push SCALE to enter menu option.
2. Choose the needed item, push the knob to confirm, it is selected when appear “*” before
the item need to set.
3. Rotate the knob or push the number button, choose the required value.
4. Push the knob to confirm, and finish the setting.
How to Crop Input Image
1. Push CROP to enter menu option.
2. Choose the needed item, push the knob to confirm, it is selected when appear “*” before
the item need to set.
3. Rotate the knob or push the number button, choose the required value.
4. Push the knob to confirm, and finish the crop setting.