RGBLink MVP 8043 Quick Start - Manual (Page 11)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
10
How to Realize Genlock
1. Input sync signal from controller or signal generator.
2. Push GEN LOCK button, key lights, the output will be sync to the reference input timing.
Each time the button push, will sync to the reference input once.
When push GENLOCK button again, the function is cancel, and the sync signal has no effect
on the device.
How to Switch Between Preview and Program
1. Boot the system default DVI1 to the current input source (key lights).
2. Choose any other signal, for example, DVI2, DVI2 button flashes, red frame of DVI2
corresponding image flashes, and the image is in Preview state.
3. Push TAKE, DVI2 key lights, and it is switched to Program output, and the former DVI1 key
flashes. Red frame of DVI1 corresponding image flashes, the image is in Preview state.
The same method, it can realize the preview and program switching among DVI3, DVI4, SDI1,
SDI2, SDI3, SDI4.