RGBLink DXP V1616 User Manual User Manual
Dxp v1616, User manual
This manual is related to the following products:
Table of contents
Document Outline
- CONTENT
- 1. Brief Introduction
- 2. Hardware Introduction
- 3. Hardware Installation
- 4. System Setup and Operations
- In This Chapter
- How to switch between input and output channel
- How to switch from one input to all outputs
- How to close one output channel
- How to close all output channels
- How to set one-to-one correspondence for input and output channel
- How to save pre-set input and output channel
- How to call pre-set input and output channel saving mode
- How to factory reset
- How to read equipment related information
- How to set LOGO display when power on
- 5. Common Questions and Solutions
- A. Specification
- B. Serial Communication Protocol
- C. Contact Information
- D. Software Upgrade