RGBLink CP 2048 - Manual (Page 2)

Touch Screen Menu Section 1 Presets Section 2
Touch Screen Menu Section
Used for system configuration, setup
and operational adjustments, such as
PIP.
Red LED
When lit, indicates
current “page” of
Presets
Four ways to access a function or a menu:
• Touch a button on the Touch Screen
• Press the Softkey adjacent to a label
• Use NAV to move the highlight, then ADJ
• Touch a line to move the highlight, then ADJ
Presets Section
Stores and recalls controller setups.
36 Presets are available 1~6 pages of
6 Presets each.
Layer Functions Section
When a layer is active, buttons in this
section apply, enabling you to change
the layer’s mode and adjust the
source.
Joystick Section
Includes a 3-axis Joystick and
dedicated buttons that enable you
to adjust PIP and many additional
system parameters.
Destinations / Aux
CP 2048 can control one or more
VSP seamless switchers.
Transition Section
Enables you to select a transition
type, and perform a Preview-to-
Program transition. Use the T-
Bar for manually mixing sources.
Output Control Section
Control Preview 1 and Program
2.
Softkeys
Softkey labels (when
present) appear on the
Touch Screen .
NAV
Move the highlight up
and down, or adjust
the labeled parameter.
ADJ
Adjust the highlighted
parameter.
Press 1-6 to light
and save Preset. Genlock function, output
will be sync to the
reference input timing. Press 1-6 to light
and select page.
Press to recall a Controller
setup (a “Preset”) to Preview.
Each button represents a
single “look” .
Jump to the next valid
Preset.
1
2
3
5
6
7
8 Source Selection
Selects the sources that are routed to
PIP. Buttons are provided for both
analog and SDI sources. 4
Lock front panel button.