RGBLink CP 2048 - Manual (Page 3)

Layer A
Layer B
Layer C
Layer D
Layer E
Back
Ground
Add Layer
Clear Layer
Split Mode
Black out
Source Selection
Each button is an input that
can be assigned to a PIP or
Aux destination Green LEDs
Solid: Source is on Program, associated destination is enabled
Blinking: Split is Off. Layer is on Program, opposite Layer on Preview
Source Selection Bar
Blinking: Source on Preview, blinking layer active for modification
Solid: Source on Preview, layer not active for modification
Joystick Section
Transition Section
Destinations / Aux
Program Control Section
5
7
4
6
8
Adjust source
within PIP or
layer
Freeze the
active layer on
Program
Adjust the size of
layers within PIP
Take active
layer to full
screen
Adjust the edges
and position of
layers within PIP
Crop boundaries
of layer.
Adjust the selected PIP. X-Axis (left/right), Y-
Axis (up/down), Z-Axis (size). Z-Axis also
adjusts value of highlighted parameter on
Touch Screen.
Connect to
low voltage
“script” light.
WIPE and MIX effects can
be assigned on a per
destination basis, and
performed simultaneously.
Select wipe
as the current
transition type
Select mix as
the current
transition type Instantly cut images
from Preview to
Program Transition automatically
from Preview to
Program. Use Effects
Menu to set transition
parameters.
T-Bar
Manually
transition
sources to/from
Program, based
on current
transition type.
CP 2048(V1.4) can control many
seamless switchers, such as VSP
729, VSP 3600, VSP 5360
simultaneously.
Select any combination of
layers on Preview:
•Blinking: Layer is selected
and active for adjustment
•Solid: Layer is selected on
Preview, but is not active for
adjustment
Press to select two or
more destinations
simultaneously
Press 1~4 to program IP to
corresponding controlled
device. Press to select all
destinations. Double-
punch to turn all off.
Preview 1
Program 2
Layer Functions Section 3
DSK setup Layer F