RGBLink Driver Quick Start - Manual (Page 8)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
7
How to Connect
Connect the HDMI output of computer to the HDMI input interface with HDMI cable.
Connect the DVI player or computer with DVI interface to the DVI interface with DVI cable.
Connect the computer to the USB control port of sending card with USB cable.
Connect the receiving card of LED Display to the Gigabit Copper Port with cable.
Plug in power cord with IEC connector.
How to Work
Push power button to ON position, the red indicator is on if the device is in normal operation.
When input DVI and HDMI signal simultaneously, the HDMI signal has priority, green signal
indicator lights, and the device output HDMI signal. Pull out the HDMI cable, green signal
indicator lights, and then the device output DVI signal.
How to Control the Brightness of Sending Card
1. First, make sure the device is in normal operation.
2. Choose the brightness value according to actual need via UP/DOWN buttons, the adjustment
value range is 1~16 for Linsn and DBstar Q2011 sending card, 0~16 for Colorlight sending
card and 0~64 for Nova MSD300 sending card. The higher the brightness value, the
brighter sending card will be.
Note: Brightness control for sending card is only available for Linsn, Colorlight, DBstar Q2011
and Nova MSD 300 currently. But if Nova sending card connected to PC software via USB,
the key operation of control brightness is invalid, though PC can still control the brightness,
user can only pull out the USB cable to recover the key brightness controlling.