beautypg.com

Sending card installation – RGBLink Driver Quick Start User Manual

Page 10

background image

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

9

Sending Card Installation

Driver controller equipped with a control panel, which compatible with different sending cards. Before

install the sending card, make sure choose the corresponding jumper cap and seal with glue. The

control panel shown in the figure below.

The following will instruct the sending card installation in detail, sending card types include DBstar,

Nova, Linsn and Colorlight.

1. DBstar Sending Card Installation

Before installation, user need to weld a needle that single row space 1.27 mm 9 pin in blue box, shown

as follows:

See also other documents in the category RGBLink Equipment: