RGBLink VSP 168S Quick Start - Manual (Page 8)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
7
How to Do Customized Output Resolution
1. Push [MENU] button to enter the menu items, turn the knob and go to PUT FORMAT>,
push the knob and confirm to go into the menu.
2. Push the knob and go into menu.
3. Turn the knob on each digital position, and change the value of the digital by the digital buttons on
the front panel.
4. After the digital, push the knob will add *, means before the * is the horizontal size. Same operation
for vertical size.
5. After the digital, push the knob will add @, means before the @ is the vertical size, and after the @ is
the refresh rate. Only digital 50 or digital 60 supports for the refresh rate. Use the digital buttons to
finish the settings.
6. After input all the values, push the knob to enable VSP 168S to output this resolution. VSP 168S will
take 5 to 10 seconds to enable this output resolution.
How to Realize Single Image Switching
1. Boot the system default CV1 to the current input source, if need seamless switching other source
such as VGA, push VGA button.
2. CV1 button light turns off after pushing VGA button. VGA button light is on if the VGA signal
is effective and stable. And if the VGA signal is invalid or no input, DVI button light will flash.
Note: Seamless switch means signal switch will not appear any flash point, black, shaking or delay.