Remotec ZXT-120 V0.5 - Manual (Page 6)

6
ZXT-120 Operations
Before using the ZXT-120, please read the [INSTALLATION] if it is
needed to mount the ZXT-120 to a wall. Power up the ZXT-120 by the
USB Power 5Vdc or Dry battery AAA x 3pcs.
• Plug-in 5Vdc power into the USB socket if operated at Always
Listening mode. Or
• Install 3xAAA batteries if operated at FLiRS mode.
• Please refer to the section of [MOUNTING PROCEDURE].
• Remove the battery cover on the back of your ZXT-120 battery
chassis.
• Mount the battery cover into the main unit with 2 screws.
• Check the polarity of the batteries and the "+/-" marks inside the
battery compartment.
• Insert the batteries.
• Push the battery cover and main unit back in place.
L CAUTION (battery and power adaptor safety)
− Use new batteries of the recommended type and size only.
− Never mix used and new batteries together.
− To avoid chemical leaks, remove batteries from the ZXT-120
if you do not intend to use the remote for an extended period
of time.
− Dispose of used batteries properly; do not burn or bury them.
(Please carefully read through the following then store the manual for
future reference.)