Remotec ZXT-120 V0.5 - Manual (Page 3)

3
Z-Extender
TM ZXT-120
(Z-Wave-to-AC IR Extender)
Operating Instructions
Introduction
The ZXT-120 is a Z-Wave to air-conditioner (AC) IR Extender (Figure
1) and it works with any Z-Wave compliant gateway or portable
controller by translating Z-Wave’s Thermostat commands to AC IR
control code. User can set the IR code from the built-in code library of
ZXT-120 through the configuration commands, or use the learning
function of ZXT-120 through the UI on gateway. ZXT-120 also built-
in a temperature sensor that allow to report your room temperature to
home gateway. It can be utilized to control or monitor your room
temperature by your smart phone or PC while you are at office, home
anywhere or around the world.
Figure 1 ZXT-120
ZXT-120 can be configured as either “Frequently Listening Routing
Slaves” (FLiRS) or “Always Listening” node after exclusion process.
FLiRS node type is targeted for battery operated applications and it
will enter sleep mode frequently in order to conserve battery
consumption that can provide the flexibility if there is out of 5Vdc
power source. Also, user can place the unit in anywhere at home.
Always Listening node type is targeted for the needs of required a fast
response application. The installed location should come with 5Vdc
power source. Always Listening node can act as a repeater, which will
re-transmit the RF signal to ensure that the signal is received by its
intended destination by routing the signal around obstacle and radio
dead spots.
ZXT-120 supports Network Wide Inclusion (NWI) and Explore
Frames. It also supports Z-Wave networks with multiple gateways and
controllers. Like every Z-Wave accessory, user will need to include the