Remotec ZXT-120 V0.5 - Manual (Page 12)

12
2
Place the ZXT-120 and
your device remote as
shown below, aimed at
each other 1-3 inches apart. -
3
Press and keep holding the
key on your original
equipment remote which
you want to learn until
LED flash and prompt on
the screen the learning
result, it may take few
seconds or more depending
on IR codes of your
remote.
When you encounter
problem, check
followings:
♦ Do not release key on
original remote before
ZXT-120 return status
during learning.
♦ Press the key on original
remote before learning
mode timeout.
♦ Keep away from
incandescent light and
direct sunlight during
learning.
♦ Make sure IR
Transmitter of your
original remote alight
with learning diode of
ZXT-120, you may also
slight adjust closer or
further away the
distance of two devices.
Some of remotes the IR
transmitter in hidden
behind lens and may not
installed center of
remote.
♦ Make sure the power is
good on both devices,
especially the original
remote. Use fresh
batteries.
• LED flashes twice
and then OFF
(learn code
success)
OR
• LED flashes six
times rapidly and
then OFF
(learn code fail)