REMKO SuperTec-Monitor - Manual (Page 6)

■ Shut down the system using the
heat pump manager.
■ Switch off the power supply of
the outdoor unit.
■ Remove the right side panel.
This is achieved by undoing
three screws on the panel and
then pulling off the panel in a
downwards direction.
■ Connect the SYSTEM MONI-
TOR using the supplied connec-
tor to the CMN socket on the
control board of the outdoor
unit.
■ From page 7 onwards, you can
find a precise description of the
associated normal value ranges
of the System Monitor.
■ In the event of a fault, you can
find a precise fault description
with cause and remedy under
the "Fault codes" section.
■ Switch the power supply of the
outdoor unit back on.
■ Place the system back into
service using the heat pump
manager.
■ DIP switch SW2 allows targeted
diagnostics to be performed
Decommissioning Operation
■ Shut down the system using the
heat pump manager.
■ Switch off the power supply of
the outdoor unit.
■ Remove the supplied connec-
tor for the SYSTEM MONITOR
from the CMN socket on the
control board of the outdoor
unit.
■ Switch the power supply of the
outdoor unit back on.
■ Place the system back into
service using the heat pump
manager.
SYSTEM MONITOR for REMKO SuperTec Inverter
REMKO SYSTEM MONITOR
FOR REMKO SUPERTEC INVERTER
6