DirecTV User Manual H20 - Manual (Page 85)

77
Options For Changing Video Output
In order to optimize the display of programs on your television, you may occasionally need to change
the resolution and/or screen format. Th ere are two keys that can be used to make changes: the
FORMAT key on the remote control and the RESOLUTION key on the front panel of the receiver.
FORMAT key on Your Remote
Pressing this key will cycle the resolutions that you’ve indicated in System Setup as being supported by
your TV. In addition, it will cycle the three available screen formats in conjunction with each individual
resolution. Available screen formats are based on the TV Aspect Ratio you set in System Setup. With
each press, an onscreen message will let you know what the current resolution/format setting is. For
example, if you indicated that your TV supports only 1080i, 480i and 480p and it is a 16:9 television,
and Native is turned off *, the cycle of settings for the FORMAT key are as follows:
1st press: 480i/Stretch 6th press: 480p/Crop
2nd press: 480i/Letter box 7th press: 1080i/Stretch
3rd press: 480i/Crop 8th press: 1080i/Letter box
4th press: 480p/Stretch 9th press: 1080i/Crop
5th press: 480p/Letter box 10th press: repeat cycle
* In Native mode, the receiver automatically adjusts resolution to match the resolution of individual
TV programs as they are tuned.
If your TV supports all formats (1080i, 720p, 480i and 480p), then your cycle would also include 720p.
If Native is turned on, the FORMAT key cycles through Stretch, Letter and Crop for the current TV
The FORMAT
key, made
simple: Keep
pressing the
FORMAT key
until you like the
picture on your
TV.