REMKO CMF-80 v.2 - Manual (Page 4)

REMKO CMF / CMT
Safety notes
These instructions are to be read
through carefully before installing
the device. They contain useful
tips and information, which are
designated by. Warning information
designed to prevent risks to persons
and property are highlighted by
Non-observance of this manual
may endanger persons, the envi-
ronment as well as the equipment
itself and will void any claims for
liability.
■ These instructions must be
stored in the immediate vicinity
of the device.
■
The unit and components may
only be set up and installed by
qualified personnel.
■ The setup, connection and
operation of the unit and its
components must be undertaken
in accordance with the operat-
ing conditions stipulated in this
manual and comply with all ap-
plicable local regulations.
■
It is prohibited to make modi-
fications or changes to equip-
ment or components supplied by
REMKO as this may cause mal-
functions and will lead to loss of
any possible claims for liability.
■ The equipment and components
should not be operated in areas
where there is a heightened risk
of damage. Observe the mini-
mum clearances.
■ The electrical supply should be
adapted to fulfil the require-
ments of the unit.
■
The operational safety of the
equipment and components is
only assured providing they are
used as intended and in a fully
assembled state. Safety devices
may not be modified or deacti-
vated.
■ Operate of equipment or com-
ponents with obvious defects or
signs of damage is prohibited.
■ All housing parts and device
openings, e.g. air inlets and
outlets, may not be blocked by
foreign items, fluids or gases.
■ The equipment and components
must be kept at a safe distance
to inflammable, explosive, com-
bustible, aggressive and dirty
areas or atmospheres.
■ Contact with equipment parts or
components can lead to burns or
injury.
■ Installation, repair and mainte-
nance work should only be car-
ried out by authorised specialists.
Inspection and cleaning can be
performed by the operator pro-
viding the equipment is not live.
■ Appropriate hazard prevention
measures are to be taken when
performing installation, repair or
maintenance, or cleaning work
on the equipment.
■
The room must be properly
ventilated before re-starting the
equipment in the event that
refrigerant leaks out from the
indoor unit. Otherwise there is
danger of suffocation.
■ Tripped circuit breakers may only
be replaced by similarly con-
structed models.
■ The units must be inspected by
a service technician at least once
annually.
■ In case of defects that endanger
the operational safety of the
unit, operation must be discon-
tinued.
■ The units may only be installed
at the points provided for this
purpose on site.
■
The devices may only be at-
tached to load-bearing struc-
tures or walls.
■ Regulations such as the regional
building regulations and the
Water Ecology Act must be
maintained.
4