REMKO CMF-80 v.2 - Manual (Page 24)

REMKO CMF / CMT
Commissioning
The commissioning and pro-
gramming of the heat pump
manager may only be car-
ried out by trained specialist
engineers.
NOTE
End
Installation
OK
■
An intensive visual inspection
is to be carried out before the
actual commissioning.
■ It is to be checked exactly
which components belong to
the heating system. The follow-
ing is an example of a hydraulic
diagram with the corresponding
parameters indicated.
■
Switch the electrical supply on.
■ The following screen appears
on the Multitalent display.
■ In order to begin installation
/ confi guration of the system,
press the OK button.
C
B
A
The heat pump manager is con-
trolled by means of the following
buttons.
The rotary knob (A)
can be used to toggle
between the displayed
menu points or to change
the set values.
Pressing the Home but-
ton (B) always brings
you back to the default
screen.
Each of the four function
keys (C) represent one
of the four lines of the
display. A menu point or
value can be selected by
pressing the F key.
Home
The operation and control of the
complete system is undertaken by
the Multitalent heat pump man-
ager.
The operation of the heat pump
manager is carried out from the
control console. The control con-
sole is supplied connected to the
basic device and is located behind
the fl ap on the indoor module.
■
The system has to be matched-
to the customer's personal
values (e.g. heating characteris-
tics).
■
The supplied brief instructions
give an overview of how to set
the most important values.
■ After confi guration, the system
is to be run-in and the meas-
ured values are to be entered
into the commissioning report.
■ The confi guration in the insta-
lation level for the selected
hydraulics has to be completely
programmed with the param-
eters shown adjacently.
The confi guration can be ac-
cepted after a power failure,
etc. by pressing the F key next
to
End .
NOTE
24