REMKO ETF 320 - Manual (Page 8)

8
REMKO ETF 320
Installation
For optimal and reliable unit ope-
ration, the following information
must be observed in any event:
■ The units must be installed sta-
ble and horizontal to
ensure unhindered
condensation drainage.
■ The units should be placed in
the centre of the room where
possible to ensure optimal air
circulation.
■ It must be ensured that the
room air can be sucked in and
blown out freely.
■ A minimum distance of 50 cm
to walls must be maintained in
any event.
■ The units must not be installed
in the immediate vicinity of
radiators or other heat sources.
■ Optimal room air circulation is
achieved when the units are
installed about 1 m above the
ground.
■ The room to be dried or dehu-
midified must always be closed
from the ambient atmosphere.
■ Open windows, doors, etc., as
well as frequently entering and
leaving the room should be
avoided as far as possible.
■ The units must not be used in
dusty, chlorine or ammonia-
containing atmospheres.
■ The unit output depends solely
on the room conditions, room
temperature, relative humidity
and observance of the installa-
tion instructions.
ATTENTION
All extension cables must only
be used uncoiled.
Electrical connection
■ The units are
operated with
230V AC/50Hz
■ �lectrical connection takes place
using the fitted power cord
with safety plug.
■ �xtension of the connecting
cable may only take place by
qualified electricians, taking into
account the cable length, unit
installed load and local use.
NOTE
Electrical connection must take
place to supply points using a
residual-current protective unit
according to VDE 0100, part
704.
For installation of the units
in damp areas such as utility
rooms, shower rooms or simi-
lar, the units must be protected
with a residual-current-opera-
ted circuit-breaker complying
with the requirements.
Wall distance
minimum 0.5 m
Maintain distance to radiators or
other heat sources.
Keep windows and doors closed!
Diagram showing installation of the REMKO dehumidifier