REMKO ETF 320 - Manual (Page 12)

12
REMKO ETF 320
All moving parts are provided
with low-maintenance permanent
lubrication. The entire refrigeration
system is hermetically sealed and
must only be repaired by author-
ised specialist companies.
■ Observe regular care and main-
tenance intervals.
■ Depending on the particular
operating conditions, the units
should be tested by an expert
for reliable operation as neces-
sary, however at least once a
year.
■ Only clean the units dry or with
a moist cloth.
Do not use a jet of water!
■ Do not use caustic cleaning
agents or those containing
solvents.
■ Only use suitable cleaning
agents to remove heavy foul-
ing.
■ Regularly check the air inlet and
outlet grilles for fouling.
Clean or replace as necessary!
Care and maintenance
ATTENTION
The power cord must never
be used for pulling or fixing
purposes.
NOTE
Regular care and maintenance
is a basic precondition for a
long useful life and trouble-
free operation of the unit.
ATTENTION
Before carrying out work on
the units, the mains plug must
be disconnected from the
power socket.
The units are provided with a
handle for easy and convenient
transport.
■ The unit must be switched off
and the plug removed from the
power socket each time before
the unit is moved to a different
location.
■ The condensation collector
must be emptied completely.
■ As long as residual moisture is
still present in the evaporator or
water is present in the conden-
sation collector, the units must
only be transported upright.
■ The transport rollers are only
suitable for use on even and
level surfaces.
■ The units must be carried if
surfaces are uneven or not
level.
NOTE
Attention must be paid to
dripping condensation.
After switching off the unit,
the evaporator can continue to
defrost under the influence of
the ambient temperature.
NOTE
Only authorised specialists
may carry out adjustments and
maintenance.
Cleaning the condenser and
evaporator
For cleaning the interior of the unit
and to gain access to the electri-
cal components, it is necessary to
open the unit housing.
■ Clean the components either by
blowing out, suction or using a
soft brush.
Do not use a jet of water!
■ Carefully clean the internal
surfaces of the units, collection
tray with hose connection, fan
and fan housing.
■ Check all unit components for
possible damage and repair if
necessary.
■ Carefully refit all previously
removed components in the
reverse order.
NOTE
The exchanger must be clea-
ned with particular care as the
delicate aluminium fins can
bend easily.
ATTENTION
After carrying out all work on
the units, an electrical safety
test must be carried out in ac-
cordance with VDE 0701.
Unit transport